ZyXEL Communications U-336S - Page 91

Fax Operation 77
Command Value Description
+FMI? Request DCE manufacturer identification.
+FMM? Request DCE model identification.
+FMR? Request DCE revision identification.
+FMS=n Minimum phase C speed parameter. refer
to +FMINSP Class 2 command in
previos section for parameter settings.
+FNR=rpr,tpr,
idr, nsr
Negotiation message reporting control
parameters:
rpr=0 Receiver parameters are not reported.
+FIS: and +FTC: response reports are
suppressed.
rpr=1 Receiver parameters are reported. +FIS:
and +FTC: response reports are
generated.
tpr=0 Transmitter Parameters are not reported.
+FCS: response reports are suppressed.
(+FCS parameter is still loaded)
tpr=1 Transmitter Parameters are reported.
+FCS: response reports are generated.
idr=0 ID Strings are not reported. +FTI: +FCI:
and +FPI: response reports are
suppressed.
idr=1 ID Strings are reported. +FNF:, +FNS:
and +FNC: response reports are
generated.
nsr=0 Non-standard frames are not reported.
+FTI: +FCI: and +FPI: response reports
are suppressed.
nsr=1 Non-standard frames are reported. +FTI:,
+FCI: and +FPI: response reports are
generated.