Set Up the 6to4 Tunnel on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Tunnel > Add,
Select Enable. Enter tunnel0 as the Interface Name and select 6to4 as the Tunnel
Mode. In the 6to4 Tunnel Parameter section, this example just simply uses the
default 6to4 Prefix, 2002:://16. Enter your Relay Router’s IP address (192.88.99.1 in
this example). Select wan1 as the Gateway. Click OK.
CONFIGURATION > Network > Interface > Tunnel
To Next Page
Loading...
