Type the Rule Name used to identify this VPN connection (and VPN gateway).
You may use 1-31 alphanumeric characters. This value is case-sensitive. Select the
rule to be Site-to-site. Click Next.
Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Scenario)
Then, configure the Secure Gateway IP as the peer MS Azure’s Gateway IP
address (in the example, 13.75.42.148); select My Address to be the interface
connected to the Internet.
Set the Negotiation, Encryption, Authentication, Key Group and SA Life Time which
MS Azure supports. Please make sure you disable Dead Peer Detection (DPD)
which is not supported in the MS Azure IKEv1 Policy-based. Type a secure Pre-
Shared Key.
To Next Page
Loading...
