How to Setup and send logs to a Vantage Reports Server
This example shows how to set up the Vantage Report Server profiles to mail
ZyWALL/USG log messages to the specific destinations. You can also specify which log
messages to Vantage Report Server. When the Vantage Report Server is configured,
you will receive the real time system logs.
ZyWALL/USG Setup and Configure sending logs to a syslog and Vantage Reports
Server
Note: All network IP addresses and subnet masks are used as examples in this
article. Please replace them with your actual network IP addresses and subnet
masks. This example was tested using USG110 (Firmware Version: ZLD 4.25).
To Next Page
Loading...
