Chapter 35 Firmware Upgrade
VMG1312-B10B / VMG1312-B30B Series User’s Guide
292
After you see the firmware updating screen, wait two minutes before logging into the Device again.
Figure 148 Firmware Uploading
The Device automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 149 Network Temporarily Disconnected
After two minutes, log in again and check your new firmware version in the Status screen.
If the upload was not successful, the following screen will appear. Click OK to go back to the
Firmware Upgrade screen.
Figure 150 Error Message
To Next Page
Loading...
