How to Configure IPSec VPN with ZyWALL IPSec VPN Client
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN
between a ZyWALL/USG and a ZyWALL IPSec VPN Client. The example instructs how
to configure the VPN tunnel between each site. When the VPN tunnel is configured,
each site can be accessed securely.
ZyWALL IPSec VPN Client with VPN Tunnel Connected
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.25) and ZyWALL IPSec VPN
Client (Firmware Version: 3.6.204.61.4).
To Next Page
Loading...
