Type the Rule Name used to identify this VPN connection (and VPN gateway).
You may use 1-31 alphanumeric characters. This value is case-sensitive. Select the
rule to be Site-to-site. Click Next.
Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Scenario)
Then, configure the Secure Gateway IP as the Cisco’s Gateway IP address (in the
example, 172.100.30.80); select My Address to be the interface connected to the
Internet.
Set the desired Negotiation, Encryption, Authentication, Key Group and SA Life
Time settings. Type a secure Pre-Shared Key (8-32 characters) which must match
your Cisco Pre-Shared Key. Click OK.
Quick Setup > VPN Setup Wizard > Wizard Type > VPN Settings (Phase 1 Setting)
To Next Page
Loading...
