Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway and click Show
Advanced Settings. Configure Authentication > Peer ID Type as Any to let the
ZyWALL/USG does not require to check the identity content of the remote IPSec router.
CONFIGURATION > VPN > IPSec VPN > VPN Gateway > Show Advanced Settings >
Authentication > Peer ID Type
Set Up the IPSec VPN Tunnel on the Cisco
To create an Address Object Name of your peer ZyWALL/USG Local IP address,
go to Networking > Address Management > Address Objects and click Add
Address. Select Network as the Type. Configure IP Address and Netmask to be
the IP address range of the network connected to the ZyWALL/USG. Click OK.
Networking > Address Management > Address Objects
To Next Page
Loading...
