Test the IPSec VPN Tunnel
Go to ZyWALL/USG CONFIGURATION > VPN > IPSec VPN > VPN Connection, click
Connect on the upper bar. The Status connect icon is lit when the interface is
connected.
CONFIGURATION > VPN > IPSec VPN > VPN Connection
Go to ZyWALL/USG MONITOR > VPN Monitor > IPSec and verify the tunnel Up Time
and Inbound(Bytes)/Outbound(Bytes) traffic.
MONITOR > VPN Monitor > IPSec
Go to Cisco VPN > VPN Status > IPsec VPN Status > Active Sessions and check the
tunnel Status is up.
VPN > VPN Status > IPsec VPN Status > Active Sessions
Go to Cisco VPN > VPN Status > IPsec VPN Status > Statics and check the Tx
Packets (Transmit data) and Rx Packets (Receive data).
VPN > VPN Status > IPsec VPN Status > Statistics
To Next Page
Loading...
