Go to CONFIGURATION > VPN > L2TP VPN > Create new Object > User to add
User Name and Password (4-24 characters). Then, set Allowed User to the newly
created object (L2TP_Remote_Users/zyx168 in this example).
CONFIGURATION > VPN > L2TP VPN > Create new Object > User
Set Up the NAT Router (Using ZyWALL USG device in this
example)
Go to CONFIGURATION > Network > NAT > Add. Select the Incoming Interface
on which packets for the NAT rule must be received. Specified the User-
Defined Original IP field and Type the translated destination IP address that this
NAT rule supports.
To Next Page
Loading...
