Configure Server Address to be the ZyWALL/USG’s WAN IP address
(172.124.163.150 in this example). Enter Account Name which should be the same
as Allowed User created in ZyWALL/USG (L2TP_Remote_Users in this example).
Then, click Authentication Settings....
In the User Authentication section, enter Password which should be the same as
Allowed User created in ZyWALL/USG (zyx123 in this example).
In the Machine Authentication section, enter Shared Secret to be the pre-shared
key of the IPSec VPN gateway the ZyWALL/USG uses for L2TP VPN over IPSec
(zyx12345 in this example). Click OK.
To Next Page
Loading...
