CONFIGURATION > Network > Interface > VTI > vti2 > Connectivity Check
7 Go to CONFIGURATION > Network > Interface > Trunk > User
Configuration > Add to create a new trunk. Add vti1 and vti2 to the new trunk.
CONFIGURATION > Network > Interface > Trunk > User Configuration > Add
8 Go to CONFIGURATION > Network > Routing > Policy Route > Add to
configure a policy route.
Source Address: LAN1_SUBNET (192.168.1.0/24)
Destination Address: BO_subnet (192.168.11.0/24)
Next-Hop: HQ_vti_trunk
SNAT: none
CONFIGURATION > Network > Routing > Policy Route > Add
To Next Page
Loading...
