Chapter 7 Wireless
WX Series User’s Guide
108
Figure 47 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 26 Network Setting > Wireless > WPS
LABEL DESCRIPTION
General
WPS Click this switch to activate or deactivate WPS on this WX Device. When the switch turns blue
, the function is enabled. Otherwise, it is not.
Add a new device with WPS Method
Method 1 Use this section to set up a WPS WiFi network using Push Button Configuration (PBC). Click this
switch to make it turn blue. Click Apply to activate WPS method 1 on the WX Device.
WPS Click this button to add another WPS-enabled WiFi device (within WiFi range of the WX Device)
to your WiFi network. This button may either be a physical button on the outside of device, or a
menu button similar to the WPS button on this screen.
Note: You must press the other WiFi device’s WPS button within 2 minutes of pressing
this button.
Method 2 Use this section to set up a WPS WiFi network by entering the PIN of the client into the WX
Device. Click this switch and make it turn blue. Click Apply to activate WPS method 2 on the
WX Device.
To Next Page
Loading...
