Chapter 7 Wireless
WX Series User’s Guide
113
Note: If the current channel is a DFS channel, the warning ‘Channel scan process is denied
because current channel is a DFS channel (Channel: 52 – 140). If you want to run
channel scan, please select a non-DFS channel and try again.’ appears.
Figure 50 Network Setting > Wireless > Channel Status
7.9 Operating Modes Settings
Use this screen to manually enter the SSID and security settings of the AP to which you want the WX
Device to connect. This screen allows you to set a profile so that the WX Device will automatically try to
connect to the AP specified in the profile each time the WX Device in Repeater mode is turned on.
Click Network Setting > Wireless > Operating Modes. The screen appears as shown.
Note: The Operating Mode is available when you select 5 GHz or 6 GHz WiFi connection in
Network Setting > Wireless > General > Band. Different Zyxel Device models support
operating mode at different band, see Table 1 on page 12 for more information.
To Next Page
Loading...
