Set up 1&1 HomeServer
Note:
Only use the original po-
wer supply delivered with
this 1&1 HomeServer!
Step 1
Place the 1&1 LTE-Antenne in a USB port
on the 1&1 HomeServer. The USB socket
is located on the base or side of the 1&1
HomeServer.
Step 2
Plug in the 1&1 HomeServer to a power
socket using the power supply cable.
The “Power / DSL” light will start to flash
after a few seconds.
Note:
Only connect the 1&1
HomeServer to the master
telephone socket! Ask a
technician to remove all
other telephone sockets
where possible, as these
may interfere with the
signal and affect your
connection.
LAN-Verbindung (wired)
Use the network cable to connect the 1&1
HomeServer to the network port on your
computer.
Continue reading on > page 12 Enter
PIN, phone number and Start-Code.
10
To Next Page
Loading...
Need help?
General
