timing that you want to adjust and enter the new delay time.
Always remember to press the “Save” button in order to store the
modifications.
To assign a macro function to a specific button, the procedure must
be as follows:
1) Go to the “Base Setting” menu;
2) Navigate to the macro option on the menu for the button that
you want to assign the function to;
3) Select the macro from the available list.
Press the “Apply” button and follow the instructions on the
confirmation message displayed in yellow.
ILLUMINATION SETTINGS
Navigate to the “LED Setting” menu. This is where you can
customize the illumination eects.
EN
To Next Page
Loading...
General