2easy VULCAN DT821 - MK Module Passcode Management

2 EASY
-16-
Input the master code.
Default: # #
Beep+, Beep
Beep+, Beep Beep+, Beep Beep+, Beep Beep+, Beep
Beep+ Beep+
Beep+ Beep
Type in code 1~12 digits
Type in code 1~12 digits
14.Setting the code
for user group1
15.Setting the code
for user group2
13.Setting the code
forTemporary2
Type in the setting code Type in the setting code
12.Setting the code
forTemporary1
18 # 19 #
20 # ~ 59 # 60 # ~ 99 #
2011 #
Type in code 1~12 digits
1006 #
Type in code 1~12 digits
2010 #
2012 #
Type in the setting code Type in the setting code
20~59 60~99
- The temporary password is for one time use and valid for 60 sec
in case first attempt was unsuccessful.
- The temporary1 is used to release the first lock,and the temporary
2 is used to release the second lock(the second lock need an
additional RLC Lock Control Interface )
- If the password length exceeds 12 digits, the keypad module will
make multiple short beep sounds “beep,beep,beep,beep” - Failed
- The temporary password can not be set the same as the master
password and the user password
- The user code group1 is used to release the first lock,and the user
code group2 is used to release the second lock (the second lock
need an additional RLC Lock Control Interface)
- The user code group1 and user code code group2 can contain 40
group passwords each
- If the password length exceeds 12 digits, the keypad module will
make multiple short beep sounds “beep,beep,beep,beep” - Failed
- The user password can not be set the same as the master
passwrd and temporary password
-
When the “ cancel” key is pressed, the indicator will show its standby color, the buzzer beeps twice , and the
system exits the setting mode
- When there isn’t any operation in 10s, the buzzer beeps twice , and the system exits the setting mode
Beep, Beep+
*
- When setting failure, the buzzer beeps twice
MK MODULE