2Go Products Diever - Abnormality Occurs During Operation; I Cant Connect My MP3 Player to My PC; 7 Safety Instructions

© 2Go Products, LLC 7
• Make sure water is not in the earphone jack. You can
shake the earphones to remove water from it.
4.5 Abnormality occurs during operation.
• If there is still no sound but the LED is flashing
normally, reset the player by pushing the pin into the
earphone jack.
• If the LED stays on but the player does not work, reset
the player as mentioned above.
Note: You will not lose the stored files due to the reset.
4.6 I can’t connect my MP3 player to my PC
• Make sure that the player is properly connected to your
PC using the USB cable.
• Make sure the USB cable is plugged into the player
before plugging the cable into your PC’s USB port. A
reverse plugging sequence may result in failure of
connection between the player and PC.
5 Safety Instructions
• Prolonged exposure to loud music may cause hearing
damage. Please avoid using extreme volume when
using this MP3 Player, especially for an extended
period of time. It’s advisable to adjust the volume at
moderate volume at all times.
• Do not use this MP3 Player while operating a motor
vehicle, or in any other instances where failure to hear
other sounds may present danger either to yourself or
others.
• Turn off your MP3 player before boarding any aircraft.