To Next PageTo Next Page
Need help?Do you have a question about the 2N 2Wire and is the answer not in the manual?
General| Brand | 2N |
|---|---|
| Model | 2Wire |
| Category | Media Converter |
| Language | English |
Enables IP intercom connection using legacy 2-wire cabling and PoE power supply, with potential mixed results on other wiring.
Facilitates long-distance Ethernet extension over 2-wire or coaxial cables.
Offers simple plug-and-play setup without requiring IP address or network configuration.
Package includes two converter units, one with a Coax/2-wire adapter.
A single power supply adapter is included, but the NZ power lead is not.
Install the master unit where Ethernet cable terminates and 2-cable wiring begins.
Install the slave unit at the remote location to convert 2-cable wiring back to Ethernet.
Connect the supplied power adapter to the master unit for operation.
Any unit can be master or slave; the master is powered by the supply, the slave by the wires.
Describes the meaning of Power, BNC, and PoE LED indicators for unit status.
Specifies 10/100 Base T speed with half/full duplex and auto-negotiation capabilities.
Compliant with IEEE 802.3 af/at standards, supporting up to 40 Watt PoE+.
Supports 2-wire, Cat 5e, Cat 6, or similar cable types.
Impedance is 25Ω to 100Ω; transmit coverage is up to 720ft (220m) with PoE, extendable to 2460ft (750m).
Steps to pair two 2N 2Wire units, involving pressing a button on each unit to initiate search mode.
Paired units will have Power and BNC LEDs shining after blinking stops.
Steps to unjoin paired units, involving pressing a button for 10 seconds until a specific LED stops shining.
Connects up to 4 slave units using coaxial cables and a splitter for different locations.
Connects up to 4 slave units using 2-wire or Cat5e/Cat6 cables to terminal blocks.
Total cable run must meet criteria; consider local power supply for slave units for best performance.
