2N EasyGate Pro Quick Start

Do not activate the power supply until the antenna is connected to
EasyGate to avoid the UMTS module damage.
2N® EasyGate Pro UMTS Connection Layout
Detailed description is in manual on CD-ROM
PIN Secured SIM Card
1. Hook off the telephone and hear the
PIN tone:
2. Enter the PIN using DTMF and press
for confirmation. Hang up the line to
cancel a wrong PIN.
3. If you hear the busy tone after a while
(a few seconds), the PIN has been
entered correctly. This PIN will be
entered automatically upon every
power up.
4. If you hear the PIN tone again after a
while, the PIN has not been entered
correctly. Re-enter the PIN.
By entering three wrong PINs you block the SIM card. Enter the PUK code
into your mobile phone to unblock the SIM card.
Indication LEDs
Power
supply
Blue light – mains supply
Yellow light – battery supply
Mobile
Network
Blue flashes – logged out
Blue light – logged in
Phone
line
No light – standby
Yellow flashes quickly – ringing
– line off-hook
Yellow light – call
Data
Green light – PC connected
Signal,
battery
indicator
Signal strength indicator
After hook off before start of dialing
– battery state
Power adapter
IN: 110 V / 240 V AC
OUT: 12 V / 1 A DC
Analog phone
(FXO interface device)
SIM
PC (USB)
SMS
input
Switch ON/OFF
(Backed-up version only)

2N EasyGate Pro Specifications

General

Mounting	DIN-rail
Device type	Cellular network gateway
Built-in display	No
Market positioning	Business
Data network	GSM
SIM interface	3 V
GSM bands supported	850, 900, 1800, 1900 MHz
USB port	Yes
USB 2.0 ports quantity	1
Antenna connector type	SMA
Input voltage	100 - 240 V
Operating temperature (T-T)	0 - 45 °C

Weight and Dimensions

Dimensions (WxDxH)	163 x 157 x 38 mm