What to do if 2N EasyGate IP gateway does not log in?
If your 2N EasyGate IP gateway doesn't log in, here are some things to check: * Make sure the SIM card is properly inserted. * Verify the SIM card doesn't require a PIN. * Check the antenna connection. * Ensure the installation site has sufficient network signal strength.
Why is there no tone after off-hook on 2N EasyGate IP?
If you can't hear a tone after going off-hook with the 2N EasyGate IP, consider the following: * Check the telephone line connection. * Be aware that the device may need about 20 seconds after power up to initialize. * Review the power and wireless failure settings located in the Service / Signaling folder.
How to fix 2N EasyGate IP gateway not communicating with PC via USB?
If your 2N EasyGate IP gateway isn't communicating with your PC via USB, try these steps: * Verify the switch is in the correct turning-on position (0/I). * Check the power supply and battery status. * If allowed by your 2N EasyGate IP settings, unlock USB using the RESET button; otherwise, reset to factory defaults.
What to do if all LED indicators are on 2N EasyGate IP?
If all the LED indicators are lit on your 2N EasyGate IP gateway, and there's no active call (with the data LED on as configured in SIP settings), try turning the device off and on again. The LEDs should turn off within 3 seconds and then show the current device status.
How to troubleshoot no LED indicator on 2N EasyGate IP?
If there's no LED indicator on your 2N EasyGate IP gateway, check that the power switch is in the 'I' (on) position instead of '0'. Also, verify the power supply and battery status.
General| GSM frequency | 850/900/1800/1900 MHz |
|---|---|
| UMTS frequency | 850/900/1900/2100 MHz |
| Operating temperature | -20°C to +55°C |
| Dimensions | 129 x 159 x 37 mm |
| Weight | 350 g |
| Supported Protocols | SIP, RTP, HTTP |
| Protocols | SIP, RTP, HTTP |
| Supported Codecs | G.711, G.729 |
To Next Page
