EasyManuals Logo

2N EasyGate IP User Manual

2N EasyGate IP
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
2N® EasyGate IP User Manual
114 / 127
1.
2.
3.
4.
5.
6.
1.
2.
3.
6. Function and Use
This section describes the basic and extending functions of 2N
®
EasyGate IP.
Here is what you can find in this section:
6.1 Phone Calls
6.2 SIP Calls
6.3 VoLTE Calls
6.4 GSM / UMTS Calls
6.5 Maintenance
6.1 Phone Calls
An outgoing/incoming call establishing procedure is described for a connected analog phone for
illustration. The procedure is the same for the 2N
®
EasyGate IPPBX connection, just make sure
that the calls are routed properly to the network to a line with 2N
®
EasyGate IP.
Outgoing Call
Put the phone off-hook, you can hear the dial tone and the Line LED starts flashing.
Dial the user number.The interdigit delay may not be longer than 5 s (or as programmed)
during dialing. The number is evaluated as complete and transmitted to the GSM network
after this timeout.
A short delay follows the last-dialed digit for 2N
®
EasyGate IP to await further dialing, if
any, which is then followed by the dialing end signal and connection setup.
If the called user is available, you will hear the ringing tone. If the called user is engaged,
you will hear the busy tone or any of the GSM provider's messages.
When the called user answers the phone, a call is established. The Line LED is statically on
during the call.
Hang up to end the call. The Line LED goes off. If the called user is the first to hang up, you
will hear the busy tone and hang up.
Incoming Call
Ringing signals an incoming call. The Line LED flashes during ringing.
Put the phone off-hook to connect the call. The Line LED is statically on during the call.
Hang up to end the call. The Line LED goes off. If the called user is the first to hang up, you
will hear the busy tone and hang up.
Automatic Call (Babycall)
If the Babycall function is enabled, a pre-programmed period of time is counted down after off-
hook. Unless you start dialing by the end of this timeout, a call to the predefined phone number
is set up automatically from this moment on, 2N
®
EasyGate IPbehaves as if dialing was

Table of Contents

Other manuals for 2N EasyGate IP

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 2N EasyGate IP and is the answer not in the manual?

2N EasyGate IP Specifications

General IconGeneral
Brand2N
ModelEasyGate IP
CategoryGateway
LanguageEnglish

Related product manuals