2N EasyGate IP - 2 N EasyGate IP User Manual; ;

2N® EasyGate IP User Manual
98 / 127
•
•
•
•
•
•
•
•
•
•
•
Service – enable / disable RS232 data connection using TCP.
State – display the current TCP state.
Idle Time – set the timeout after which the TCP server connection is terminated if no data
is transmitted.
FIFO Queue Size – set the queue size according to the FIFO rules (first in, first out).
Transmission Debugging – enable data transmission to the log in both directions to
monitor the whole RS232 - server communication.
5.9.2.1 TCP
State– display the current TCP state.
Server Name– set the TCP server name.
Server Port– set the TCP server port.
TCP no delay– allow instantaneous sending of data received by the device. By allowing
the function you force instantaneous sending of data to the TCP server.
Connection Timeout– define how long2N
®
EasyGate IPshall try to establish connection
with the TCP server.
Reconnect– enable the parameter to make2N
®
EasyGate IPtry to reconnect in the case
of a socket error. The device shall repeat the attempts until the end of the connection
timeout.