2N EasyGate IP - 2 N EasyGate IP User Manual; 2.6 RESET Button Function; Factory Default Reset; Restart

2N® EasyGate IP User Manual
21 / 127
•
•
•
•
•
Green twice in 2.75 s (0.25 s/0.25 s) – data available, 2N Elevator Center
disabled or device
not added to 2N Elevator Center account, SIP registration in progress,
but SIP not registered (check SIP settings)
Signal
Indication of signal strength (LED count) and used technology (first LED
color)
Yellow – 2G (−104, −98, −89, −80 dB)
Green – 3G (−106, −100, −90, −80 dB)
Blue – 4 G (−100, −90, −80, −70 dB)
The signal LED indicators also indicate such action statuses
as:
factory reset software restart firmware upgrade
2.6 RESET Button Function
The RESET button located on the 2N
®
EasyGate IP bottom side is used for factory default reset
or restart of the device.
Factory Default Reset
To reset the factory default values, press and hold the RESET button for approximately 20
seconds until the separate red LED indicator in position 1 among the signal LEDs goes on.
Now release the RESET button to reset the factory default values. While the
RESET button is being pressed, the blue power LED indicator is on.
Restart
To HW restart the device, press the RESET button shortly. The power LED flashes shortly to
signal the button press.