Note
The microphone sound guides are normally loose after the front panel is
removed! The screw is only used as a fall-out protection during
installation.
Warning
Be sure keep strictly the hole dimensions while mounting the device into
classic bricks without the flush mounting box as shown in the picture with
dimensions.
Flush Mounting – Classic Bricks
What You Need:
A precisely cut hole or, optionally, the brick flush mounting box, Part No. 9151001
Hole: (132 × 223 × 83) mm (with flush mounting box)
Hole: (112 × 220 × 70) mm (without flush mounting box)
To Next Page
Loading...
