2N TELEKOMUNIKACE a. s., Modřanská 621, 143 01 Praha 4, Czech Republic, tel.: +420 261 301 111, fax: +420 261 301 999,

e-mail: obchod@2n.cz IČO: 26183960, DIČ: CZ 26183960, Společnost je zapsaná v obchodním rejstříku vedeném Městským soudem

v Praze, oddíl B, vložka 6613. Č.Ú.: 51-1400870237/0100, 714154001/2400, 188430466/0300 www.2n.cz

How to install tamper switch to protect Helios IP against

unauthorized entry

This manual is valid for Helios IP Force and Helios IP Safety. You can use RFID card

reader as well as additional relay to place tamper switch!

Also mind that HW tamper switch can be used in Helios IP UNI, more info you can find in

installation manual of Helios IP UNI!

Since 2013 will be tamper switch attached to CPU, so you will have possibility to

configure function which will be started when activation tamper switch will be done,

more info in configuration manual!

1. As very first step you have to uncover front panel. Use torx screw 4 mm (Pic. 1). In

the (Pic. 2) see necessary accessories you will need during the installation.

Pic. 1 Pic. 2 Pic. 3

2. Then you need to remove key panel. Use cross-point screw driver.

Pic. 4

2N Helios IP Force - Page 8

Other manuals for 2N Helios IP Force