Caution
The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the
first sound signal for security reasons. The inter-digit delay may be 2 s at
most
.
2N Helios IP Force
®
gets the IP address upon restart only if the DHCP server is
configured properly.
Mode Switching with 1 or 2-Button Models
In case your device is equipped with 1 or 2 buttons, you can 2N Helios IP Force
®
switch the modes using one button only.
Connect to the power supply (or, disconnect and reconnect 2N Helios IP Force
®
it if already connected).
Wait for the first acoustic signal .
Press the first quick dial button 15 times.
The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
To Next Page
Loading...
