3Com 3824 - Page 25

Aggregated Links 25
Figure 6 An 8 Gbps aggregated link between two Switch units
To manually set up this configuration:
1 Prepare ports 2, 4, 6 and 8 on the upper Switch for aggregated links. To
do this:
a Check that the ports have an identical configuration using your
preferred management interface.
b Add the ports 2, 4, 6 and 8 on the specified unit to the aggregated
link.
2 Prepare ports 2, 4, 6 and 8 on the lower Switch for aggregated links. To
do this:
a Check that the ports have an identical configuration using your
preferred management interface.
b Add the ports 2, 4, 6 and 8 on the specified unit to the aggregated
link.
3 Connect port 2 on the upper Switch to port 2 on the lower Switch.
4 Connect port 4 on the upper Switch to port 4 on the lower Switch.
5 Connect port 6 on the upper Switch to port 6 on the lower Switch.
6 Connect port 8 on the upper Switch to port 8 on the lower Switch.
Switch
Switch
8 Gbps Aggregated Link