3Com 3CR17660-91 - Page 24

24 3Com Switch 4200G Family
Command Reference
mac-address
Use the mac-address command to add/modify the MAC address table entry.
System view
Port view
Web command: Port -> Administration
mac-address max-mac-count
Use the mac-address max-mac-count command to configure the maximum number of MAC addresses an
Ethernet port can learn.
Ethernet Port view
mac-address max-mac-count 0
Use the mac-address max-mac-count0 command to disable a switch from learning MAC address in a
VLAN.
VLAN view
mac-address multicast interface vlan
Use the mac-address multicast command to add a multicast MAC address entry.
System view
mac-address multicast vlan
Use the mac-address multicast vlan command to add a multicast MAC address entry.
Ethernet Port view
mac-address security
Use the mac-address security command to add Security MAC address manually.
Ethernet Port view
System view
mac-address timer
Use the mac-address timer command to set the aging time for dynamic MAC address entries.
System view
mac-authentication
Use the mac-authentication command to enable centralized MAC address authentication globally (current
device) or on specified ports.
System view
Ethernet Port view
mac-authentication authmode
Use the mac-authentication authmode command to set MAC address authentication mode.
System view
mac-authentication authpassword
Use the mac-authentication authpassword command to set a password for MAC address authentication
when the fixed mode is adopted.
System view
mac-authentication authusername
Use the mac-authentication authusername command to set a user name when a switch authenticates
users in fixed mode.
System view
mac-authentication domain
Use the mac-authentication domain command to configure an ISP domain for centralized MAC address
authentication users.
System view
mac-authentication timer
Use the mac-authentication timer command to configure the timers used in centralized MAC address
authentication.
System view
management-vlan
Use the management-vlan command to specify the management VLAN on the switch.
System view
management-vlan synchronization enable
Use the management-vlan synchronization enable command to enable the management VLANs of the
member devices of a cluster to be synchronized.
Cluster view
mdi
Use the mdi command to set port MDI attribute.
Ethernet Port view