3Com 4200G Installation Guide

1
3Com Switch 4200G
10G Interface Module
Installation Guide
1. XFP Interface Module
1.1 Appearance and front panel
Figure 1 Appearance of an XFP interface module
Figure 2 Front panel an XFP interface module
1.2 Installation
Step 1: Put on an ESD-preventive wrist strap and verify it is properly
grounded. Then remove the XFP interface module from the package.
Step 2: Loosen the filler panel mounting screws on the rear panel of the
switch with a screwdriver and remove the filler panel.
Step 3: Hold the fastening screws on the front panel of the XFP interface
module, and gently push the module in along the slot guide rail until the
module is in close contact with the switch.
Step 4: Tighten the fastening screws with a screwdriver to secure the XFP
interface module.

3Com 4200G Specifications

General

Model	4200G
Jumbo Frame Support	Yes
Manageable	Yes
Uplink Ports	4
Management	Web, SNMP, CLI
Power Supply	Internal
Features	VLAN, QoS, Link Aggregation, Spanning Tree
Dimensions	44.0 x 32.0 x 4.4 cm
Ports	48
Layer	Layer 2/3
MAC Address Table Size	16, 000 entries