3Com 5500-SI - Page 14

3Com Switch 5500 Family
Quick Reference Guide
display drv
Use the display drv command to display MNT module driver debugging information.
Any view
display fan
Use the display fan command to display the working state of the built-in fans.
Any view
display fib
Use the display fib command to view the summary of the forwarding information base.
Any view
display fib
Use the display fib command to view the FIB entries which are output from the buffer according to regular
expression and related to the specific character string.
Any view
display fib acl
Use the display fib acl command to view the FIB entries matching a specific ACL.
Any view
display fib ip_address
Use the display fib ip_address command to view the FIB entries matching the destination IP address
(range).
Any view
display fib ip-prefix
Use the display fib ip-prefix command to view the FIB entries matching the specific prefix list.
Any view
display fib statistics
Use the display fib statistics command to view the total number of FIB entries.
Any view
display ftm
Use the display ftm information command to display FTM protocol information.
Any view
display ftp-server
Use the display ftp-server command to display the parameters of the current FTP Server. You can
perform this command to verify the configuration after setting FTP parameters.
Any view
display ftp-server source-ip
Use the display ftp-server source-ip command to display the source IP address of the FTP server. If
no source IP address is specified, 0.0.0.0 is displayed.
Any view
display ftp source-ip
Use the display ftp source-ip command to display the source IP address of the FTP client. If no source
IP address is specified, 0.0.0.0 is displayed.
Any view
display ftp-user
Use the display ftp-user command to display the parameters of current FTP user. You can perform this
command to examine the configuration after setting FTP parameters.
Any view
display garp statistics
Use the display garp statistics command to display the GARP statistics.
Any view
display garp timer
Use the display garp timer command to display the values of the GARP timers.
Any view
display gvrp statistics
Use the display gvrp statistics command to display the GVRP statistics about all or specified Trunk
ports.
Any view
display gvrp status
Use the display gvrp status command to display the enable/disable status of global GVRP.
Any view