3Com 5500-SI - Page 15

3Com Switch 5500 Family 15
Quick Reference Guide
display history-command
Use the display history-command command to view the commands previously entered during this login
session, up to a specified maximum.
Any view
display hwtacacs
Use the display hwtacacs command to view configuration information of one or all HWTACACS schemes.
Any view
display icmp statistics
Use the display icmp statistics command to view the statistics information about ICMP packets.
Any view
display igmp group
Use the display igmp group command to view the member information of the IGMP multicast group.
Any View
display igmp interface
Use the display igmp interface command to view the IGMP configuration and running information on an
interface.
Any view
display igmp-snooping configuration
Use the display igmp-snooping configuration command to display the configuration information about
IGMP Snooping.
Any view
display igmp-snooping group
Use the display igmp-snooping group command to display information about the IP and MAC multicast
groups under one VLAN (with vlan vlan-id) or all VLANs (without vlan vlan-id).
Any view
display igmp-snooping statistics
Use the display igmp-snooping statistics command to display the message statistics about IGMP
Snooping.
Any view
display info-center
Use the display info-center command to display the configuration of system log and the information
recorded in the memory buffer.
Any view
display interface
Use the display interface command to view the configuration information on the selected interface.
Any view
display interface VLAN-interface
Use the display interface vlan-interface command to view the information about a specific VLAN
interface, or all VLAN interfaces.
Any view
display ip host
Use the display ip host command to display all host names and their corresponding IP addresses.
Any view
display ip interface vlan-interface
Use the display ip interface vlan-interface command to view information on the specified interface.
Any view
display ip ip-prefix
Use the display ip ip-prefix command to view the address prefix list.
Any view
display ip routing-table
Use the display ip routing-table command to view a summary of routing table information.
Any view
display ip routing-table acl
Use the display ip routing-table acl command to view the route filtered through the specified ACL.
Any view.
display ip routing-table ip_address
Use the display ip routing-table ip_address command to view routing information for a specific IP
address, and you can also choose the type of information to display.
Any view