3Com 5500-SI - Page 20

3Com Switch 5500 Family
Quick Reference Guide
display poe power
Use the display poe interface power command, you can view the power information of a specific port
or all ports on the Switch.
Any view
display poe power supply
Use the display poe powersupply command to view the parameters of the power sourcing equipment
(PSE).
Any view
display poe-profile
Use the display poe-profile command to display detailed configuration information of the created PoE
Profile for a switch.
Any view
display port
Use the display port hybrid command to view the ports whose link type is hybrid. Use the display port
trunk
command to view the ports whose link type is trunk.
Any view
display port-security
Use the display port-security command to display the information about port security configuration
(including global configuration and all or specific port configuration).
Any view
display port vlan-vpn
Use the display port vlan-vpn command to display the information about VLAN VPN configuration of the
current system, including current IPID value, VLAN-VPN ports, VLAN-VPN uplink ports and whether the
inner tag priority replication function is enabled.
Any view
display power
Use the display power command to display the working state of the built-in power supply.
Any view
display protocol-priority
Use the display protocol-priority command to display the priority of protocol packets.
Any view
display protocol-vlan interface
Use the display protocol-vlan interface command to display the protocol information and protocol
indexes configured for specified ports.
Any view‘
display protocol-vlan vlan
Use the display protocol-vlan vlan command to display the protocol information and protocol indexes
configured for specified VLANs.
Any view
display qos cos-local-precedence-map
Use the display qos cos-local-precedence-map command to view COS and Local-precedence map
Any view
display qos-interface all
Use the display qos-interface all command to display all the QoS settings of the port.
Any view
display qos-interface line-rate
Use the display qos-interface line-rate command to view the traffic rate limitations of the interface
output.
Any view
display qos-interface mirrored-to
Use the display qos-interface mirrored-to command to view the settings of the traffic mirror.
Any view
display qos-interface traffic-limit
Use the display qos-interface traffic-limit command to view the traffic limit settings.
Any view
display qos-interface traffic-priority
Use the display qos-interface traffic-priority command to view the traffic priority settings.
Any view