3Com 5500-SI - Page 22

3Com Switch 5500 Family
Quick Reference Guide
display rsa local-key-pair public
Use the display rsa local-key-pair public command to display the public key of the server host key
pair. If no key pair is generated, the system prompts “RSA keys not found”.
Any view
display rsa peer-public-key
Use the display rsa peer-public-key command to display the client public key of the specified RSA key
pair. If no key name is specified, the command displays all public keys of the client
Any view
display saved-configuration
Use the display saved-configuration command to display the current configuration file in the flash
memory of an Ethernet switch.
Any view
display schedule reboot
Use the display schedule reboot command to check the configuration of related parameters of the switch
schedule reboot terminal service.
Any view
display sftp source-ip
Use the display sftp source-ip command to display the source IP address of the SFTP client. If no
source IP address is specified, 0.0.0.0 is displayed.
Any view
display snmp-agent
Use the display snmp-agent engineid command to view the engine ID of current device.
Any view
display snmp-agent community
Use the display snmp-agent community command to display the currently configured community names.
Any view
display snmp-agent group
Use the display snmp-agent group command to display group name, safe mode, state of various views
and storage modes.
Any view
display snmp-agent mib-view
The display snmp-agent mib-view command is used to view the MIB view configuration information of
the Switch.
Any view
display snmp-agent statistics
Use the display snmp-agent statistics command to view the current state of SNMP communication.
Any view
display snmp-agent sys-info
Use the display snmp-agent sys-info command to view the system information of SNMP configuration.
Any view
display snmp-agent trap-list
Use the display snmp-agent trap-list command to display trap list information.
Any view
display snmp-agent usm-user
Use the display snmp-agent usm-user command to view information of all the SNMP usernames in the
group username list.
Any view
display snmp-proxy unit
Using display snmp-proxy unit command, you can view statistics information of SNMP proxy.
Any view
display ssh server
Use the display ssh server command to display the status or session information about the SSH server
Any view
display ssh server-info
Use the display ssh server-info command to display the association between the server public keys
configured on the client and the servers.
Any view