3Com 5500-SI - Page 26

3Com Switch 5500 Family
Quick Reference Guide
dot1x port-control
Use the dot1x port-control command to configure the mode for 802.1x to perform access control on the
specified interface.
Ethernet Port view
dot1x port-method
Use the dot1x port-method command to configure the base for 802.1x to perform access control on the
specified interface.
Ethernet Port view
dot1x quiet-period
Use the dot1x quiet-period command to enable the quiet-period timer.
System view
dot1x retry
Use the dot1x retry command to configure the maximum times a Switch can retransmit the authentication
request frame to the supplicant.
System view
dot1x retry-version-max
Use the dot1x retry-version-max command to set the maximum number of retries for a switch to send
version request packets to an online supplicant system.
System view
dot1x supp-proxy-check
Use the dot1x supp-proxy-check command to enable the supplicant system checking function for
specified Ethernet ports.
System view
Ethernet Port view
dot1x timer
Use the dot1x timer command to configure the 802.1x timers.
System view
dot1x timer ver-period
Use the dot1x timer ver-period command to set the version checking timer for 802.1x client.
System view
dot1x version-check
Use the dot1x version-check command to enable 802.1x client version checking for specified Ethernet
ports.
System view
Ethernet Port view
duplex
Use the duplex command to configure the duplex mode of an Ethernet port to auto-negotiation, full duplex
or half-duplex.
Ethernet Port view
enable snmp trap updown
Use the enable snmp trap updown command to enable the current port to transmit the LINK UP and LINK
DOWN trap information.
Ethernet Port view
end-station polling ip-address
Use the end-station polling ip-address command to configure the IP address requiring periodic testing.
System view
execute
Use the execute command to execute the specified batch file.
System view
exit
Use the exit command to terminate the connection to the remote SFTP server and return to system view.
This command has the same function as the
bye and quit commands.
SFTP Client view
expired
Use the expired command to configure the lease time of the IP addresses in a global DHCP address pool.
DHCP Address Pool view
fabric port enable
Use the fabric port enable command to configure a port to be a fabric port.
System view