3Com 5500-SI - Page 25

3Com Switch 5500 Family 25
Quick Reference Guide
dldp
Use the dldp command to either enable or disable the DLDP on either all the optical switches or current
switch.
System view
Ethernet Port view
dldp authentication-mode
Use the dldp authentication-mode command to set the DLDP authentication mode and password for the
ports of the local and peer devices.
System view
dldp interval
Use the dldp interval command to set the time interval for sending advertisement packets.
System view
dldp reset
Use the dldp reset command to reset the DLDP status of either the current port or all the ports disabled
by DLDP.
System view
Ethernet Port view
dldp unidirectional-shutdown
Use the dldp unidirectional-shutdown command to set DLDP handling mode when a unidirectional link
is found.
System view
dldp work-mode
Use the dldp work-mode command to set the DLDP operating mode.
System view
dns-list
Use the dns-list command to configure one or multiple DNS server IP addresses for a global DHCP
address pool.
DHCP Address Pool view
domain
Use the domain command to configure an ISP domain or enter the view of an existing ISP domain.
System view
domain-name
Use the domain-name command to configure a domain name for the DHCP clients of a global DHCP
address pool.
DHCP Address Pool view
dot1x
Use the dot1x command to enable 802.1x on the specified port or globally, (that is on the current device).
Ethernet Port view
dot1x authentication-method
Use the dot1x authentication-method command to set 802.1x authentication mode.
System view
dot1x authentication-method
Use the dot1x authentication-method command to configure the authentication method for the 802.1x
user.
System view
dot1x dhcp-launch
Use the dot1x dhcp-launch command to set 802.1x to prevent the Switch from triggering user ID
authentication for users who configure static IP addresses in a DHCP environment.
System view
dot1x guest-vlan
Use the dot1x guest-vlan command to enable the Guest VLAN function for specified Ethernet ports.
System view
Ethernet Port view
dot1x max-user
Use the dot1x max-user command to configure a limit to the amount of supplicants on the specified
interface using 802.1x.
Ethernet Port view