3Com 5500-SI - Page 28

3Com Switch 5500 Family
Quick Reference Guide
ftp { cluster | remote-server } source-interface
Use the ftp { cluster | remote-server } source-interface command to use a specified source
interface to establish a connection with an FTP server.
User view
ftp { cluster | remote-server } source-ip
Use the ftp { cluster | remote-server } source-ip command to use a specified source IP address
to establish a connection with an FTP server.
User view
ftp dir
Use the dir command to query a specified file.
FTP Client view
ftp disconnect
Use the ftp disconnect command to terminate the FTP connection of a specified user at the FTP server
end.
System view
ftp-server
Use the ftp-server command to configure a public FTP server on the management device for cluster
members.
Cluster view
ftp server enable
Use the ftp server enable command to enable FTP server and allow FTP users to log in.
System view
ftp-server source-interface
Use the ftp-server source-interface command to specify source interface for the FTP server.
System view
ftp-server source-ip
Use the ftp-server source-ip command to specify source IP address for the FTP server.
System view
ftp source-interface
Use the ftp source-interface command to specify source interface for the FTP client.
System view
ftp source-ip
Use the ftp source-ip command to specify source IP address for the FTP client.
System view
ftp timeout
Use the ftp timeout command to configure connection timeout interval.
System view
garp timer
Use the garp timer command to set the GARP Hold, Join or Leaver timer of the port to a specified value.
Ethernet Port view
garp timer leaveall
Use the garp timer leaveall command to set the GARP LeaveAll timer to a specified value.
System view
gateway-list
Use the gateway-list command to configure one or multiple gateway IP addresses for the DHCP clients
of a DHCP address pool.
DHCP Address Pool view
get
Use the get command to download a remote file and save the file to the local device.
FTP Client Command view
gratuitous-arp learning enable
Use the gratuitous-arp-learning enable command to enable the gratuitous ARP packet learning
function.
System view
gvrp
Use the gvrp command to enable GVRP globally (in system view) or on a port (in Ethernet port view).
System view
Ethernet Port view