3Com 5500-SI - Page 29

3Com Switch 5500 Family 29
Quick Reference Guide
gvrp registration
Use the gvrp registration command to configure the GVRP registration type on a port.
Ethernet Port view
header
Use the header command to configure the system to display a header during user log in.
System view
help
Use the help command to get the help information about the specified or all SFTP client commands.
SFTP Client view
history-command max-size
Use the command history-command max-size to specify the amount of previously entered commands that
you want the Switch to save.
User Interface view
holdtime
Use the holdtime command to configure the valid holdtime of a switch.
Cluster view
host-route
Use the host-route command to configure RIP to accept host routes. This is the default.
RIP view
hwtacacs nas-ip
Use the hwtacacs nas-ip command to specify the source address of the hwtacacs packet sent from NAS.
System view
hwtacacs scheme
Use the hwtacacs scheme command to enter the HWTACACS view. If you specified a nonexistent scheme,
a new HWTACACS scheme will be created.
System view
icmp
Use the icmp command to specify the Internet Control Message Protocol (ICMP) parameters.
Any view
idle-cut
Use the idle-cut command to configure the user template in the current ISP domain.
ISP Domain view
idle-timeout
Use the idle-timeout command to configure the amount of time you want to allow a user interface to
remain idle before it is disconnected.
User Interface view
if-match { acl | ip-prefix }
Use the if-match { acl | ip-prefix } command to configure the IP address range to match the
Route-policy.
Route Policy view
if-match cost
Use the if-match cost command to configure one of the match rules of route-policy to match the cost of
the routing information.
Route Policy view
if-match interface
Use the if-match interface command to match the route whose next hop is the designated interface.
Route Policy view
if-match ip next-hop
Use the if-match ip next-hop command to configure one of the match rules of route-policy on the next
hop address of the routing information.
Route Policy view
if-match tag
Use the if-match tag command to match the tag field of OSPF route information.
Route Policy view
igmp enable
Use the igmp enable command to enable IGMP on an interface.
VLAN Interface view