3Com 5500-SI - Page 30

3Com Switch 5500 Family
Quick Reference Guide
igmp group-limit
Use the igmp group-limit command to configure the maximum number of multicast groups that can be
added to a VLAN interface.
VLAN Interface view
igmp group-policy
Use the igmp group-policy command to set the filter of multicast groups on an interface to control the
accessing to the IP multicast groups.
VLAN Interface view
igmp host-join
Use the igmp host-join command to enable a port in the VLAN interface of an ethernet Switch to join a
multicast group.
VLAN Interface view
igmp lastmember-queryinterval
Use the igmp lastmember-queryinterval command to set the time interval before IGMP query router
sends the IGMP group query message after it receives the IGMP Leave message from the host.
VLAN Interface view
igmp max-response-time
Use the igmp max-response-time command to configure the maximum response time contained in the
IGMP query messages.
VLAN Interface view
igmp proxy
Use the igmp proxy command to specify an interface of an edge-network Layer 3 switch as the IGMP proxy
interface of another interface.
Interface view
igmp robust-count
Use igmp robust-count command to set the number of sending the IGMP group query message after the
IGMP Querier receives the IGMP Leave message from the host.
VLAN Interface view
igmp-snooping
Use the igmp-snooping command to enable or disable the IGMP Snooping.
System view
VLAN view
igmp-snooping fast-leave
Use the igmp-snooping fast-leave command to enable IGMP fast leave processing.
Ethernet Port view
igmp-snooping group-limit
Use the igmp-snooping group-limit command to set the maximum number of multicast groups the port
can join.
Ethernet Port view
igmp-snooping group-policy
Use the igmp-snooping group-policy command to configure an IGMP Snooping filter ACL.
System view
Ethernet Port view
igmp-snooping host-aging-time
Use the igmp-snooping host-aging-time command to set the aging time of multicast member ports.
System view
igmp-snooping max-response-time
Use the igmp-snooping max-response-time command to configure the maximum query response time.
System view
igmp-snooping router-aging-time
Use the igmp-snooping router-aging-time command to configure the aging time of the router port.
System view
igmp timer other-querier-present
Use the igmp timer other-querier-present command to configure the timer of presence of the IGMP
querier.
VLAN Interface view
igmp timer query
Use the igmp timer query command to configure the interval at which a router interface sends IGMP query
messages.
VLAN Interface view