3Com 5500-SI - Page 31

3Com Switch 5500 Family 31
Quick Reference Guide
igmp version
Use the igmp version command to specify the version of IGMP that a router uses.
VLAN Interface view
import-route
Using the import-route command, you can import the external routing information of another routing
protocol.
OSPF view
import-route
Use the import-route command to import the routes of other protocols into RIP.
RIP view
import-source
Use the import-source command to specify the (S, G) entries in this domain that need to be advertised
when an MSDP peer creates an SA message.
MSDP view
info-center channel name
Use the info-center channel name command to rename a channel specified by the channel-number as
channel-name.
System view
info-center console channel
Use the info-center console channel command to configure the channel through which the log
information is output to the console.
System view
info-center enable
Use the info-center enable command to enable the system log function.
System view
info-center logbuffer
Use the info-center logbuffer command to configure output information to the memory buffer.
System view
info-center loghost
Use the info-center loghost command to set the IP address of the info-center loghost to send information
to it.
System view
info-center loghost source
Use the info-center loghost source command to set the source address of packets sent to the loghost
as the address of the interface specified by the interface-name parameter.
System view
info-center monitor channel
Use the info-center monitor channel command to set the channel to output the log information to the
user terminal.
System view
info-center snmp channel
Use the info-center snmp channel command to specify new channel for transmitting the SNMP
information.
System view
info-center source
Use the info-center source command to add/delete a record to the information channel.
System view
info-center switch-on
Use the info-center switch-on command to turn on the information synchronization switch of the
specified switch.
System view
info-center synchronous
Use the info-center synchronous command to enable the synchronous information output function.
System view
info-center timestamp
Use the info-center timestamp command to configure the timestamp output format in debugging/trap
information.
System view