3Com 5500-SI - Page 32

3Com Switch 5500 Family
Quick Reference Guide
info-center timestamp loghost
Use the info-center timestamp loghost command to set the format of time stamp to be sent to log host.
System view
info-center trapbuffer
Use the info-center trapbuffer command to output information to the trap buffer.
System view
instance
Use the instance command to map specified VLANs to a specified spanning tree instance.
MST Region view
interface
Use the command interface interface_type interface_number to enter the interface of the
specified port.
System view
interface VLAN-interface
Use the interface vlan-interface command to enter a VLAN interface view and use the related
configuration commands.
System view
ip address
Use the ip address command to configure either the primary or secondary IP address and IP subnet mask
for a VLAN interface.
VLAN Interface view
ip address bootp-alloc
Use the ip address bootp-alloc command to configure VLAN interface to obtain IP address using
BOOTP.
VLAN Interface view
ip address dhcp-alloc
Use the ip address dhcp-alloc command to configure VLAN interface to obtain IP address using DHCP.
VLAN Interface view
ip host
Use the ip host command to configure the host name and the host IP address in the Switch 5500’s host
table. This allows you to ping or Telnet a local device by host name.
System view
ip http acl
Use the ip http acl command to call an ACL and perform ACL control over the WEB network
management users.
User Interface view
ip ip-prefix
Use the ip ip-prefix command to configure an address prefix list or one of its items.
System view
ip-pool
Use the ip-pool command to configure a private IP address range for cluster members on the switch to
be set as the management device.
Cluster view
ip route-static
Use the ip route-static command to configure a static route, whose validity depends on detecting results
as follows: valid when the detecting result is reachable or invalid when the detecting result is unreachable.
System view
jumboframe enable
Use the jumboframe enable command to allow jumbo frames to pass through the specified Ethernet port.
Ethernet Port view
key
Use the key command to configure a shared key for HWTACACS authentication, authorization or
accounting.
HWTACACS view
lacp enable
Use the lacp enable command to enable LACP.
Ethernet Port view