3Com 5500-SI - Page 35

3Com Switch 5500 Family 35
Quick Reference Guide
memory auto-establish enable
Use the memory auto-establish enable command to allow the routing protocol connection that is forcibly
disconnected to recover automatically when the idle memory of the Switch reaches this value.
System view
memory { safety | limit }
Use the memory command to configure the limit or safety of the Switch idle memory.
System view
messenger
Use the messenger time command to enable or disable the messenger alert and configure the related
parameters.
ISP Domain view
mirrored-to
Use the mirrored-to command to enable ACL traffic identification and perform traffic mirroring.
Ethernet Port view
mirroring group
Use the mirroring-group command to configure the port mirroring group.
System view
mirroring-group mirroring-port
Use the mirroring-group mirroring-port command to configure the monitored port.
System view
mirroring-group monitor-port
Use the mirroring-group monitor-port command to configure the monitoring port.
System view
mirroring-group reflector-port
Use the mirroring-group reflector-port command to configure a reflector port.
System view
mirroring-group remote-probe vlan
Use the mirroring-group remote-probe vlan command to specify the remote-probe VLAN for a given
mirroring group.
System view
mirroring-port
Use the mirroring-port command to configure a mirroring port.
Ethernet Port view
mkdir
Use the mkdir command to create a directory on the remote SFTP server.
SFTP Client view
monitor-port
Use the monitor-port command to configure a monitor port.
Ethernet Port view
more
Use the more command to display the contents f of the specified file formatted as text.
User view
move
Use the move command to move files.
User view
msdp
Use the msdp command to enable MSDP and enter MSDP view.
System view
msdp-tracert
Use the msdp-tracert command to trace the path along which an SA message travels, so as to locate
message loss and minimize configuration errors. After determining the path of the SA message, you can
prevent SA flooding through correct configuration.
Any view
multicast route-limit
Use the multicast route-limit command to limit the capacity of multicast routing table.
System view
multicast routing-enable
Use the multicast routing-enable to enable IP multicast routing.
System view