3Com 5500-SI - Page 36

3Com Switch 5500 Family
Quick Reference Guide
multicast-source-deny
Use the multicast-source-deny command to enable the multicast source deny feature.
System view
Ethernet Port view
multicast-suppression
Use multicast-suppression to configure the amount of multicast traffic that will be accepted on a port.
Ethernet Port view
name
Use the name command to set a name for the assigned VLAN.
VLAN view
nas-ip
Use the nas-ip command to set the source IP address for HWTACACS packets sent from the NAS (switch),
such that all the packets sent to the TACACS server carry the same source IP address.
HWTACACS view
nbns-list
Use the nbns-list command to configure one or multiple NetBIOS server IP addresses for the DHCP
clients of a global DHCP address pool.
DHCP Address Pool view
ndp enable
Use the ndp enable command to enable NDP on a system in system view, or to enable it on a port in
Ethernet port view.
System view
Ethernet Port view
ndp timer aging
Use the ndp timer aging command to set how long a device will hold the NDP packets received from the
local device. After the aging timer expires, the device will discard the received NDP neighbor node
information.
System view
ndp timer hello
Use the ndp timer hello command to define how often to transmit the NDP packets.
System view
netbios-type
Use the netbios-type command to configure the DHCP clients of a global address pool to be of specified
NetBIOS node type.
DHCP Address Pool view
network
Use the network command to configure a dynamically assigned IP address range (where IP addresses will
be dynamically assigned to DHCP clients).
DHCP Address Pool view
nm-interface vlan-interface
Use the nm-interface vlan-interface command to specify the network management (NM) interface of a
management switch.
Cluster view
nssa
Using the nssa command, you can configure the type of an OSPF area as an NSSA area.
OSPF Area view
ntdp enable
Use the ntdp enable command to enable NTDP on a system in system view, or to enable it on a port in
Ethernet port view.
System view
Ethernet Port view
ntdp explore
Use the ntdp explore command to start topology information collection.
User view
ntdp hop
Use the ntdp hop command to configure a limit to the hops for topology collection.
System view
ntdp timer
Use the ntdp timer command to configure the topology collection interval.
System view