3Com 5500-SI - Page 37

3Com Switch 5500 Family 37
Quick Reference Guide
ntdp timer hop-delay
Use the ntdp timer hop-delay command to set delay for collected devices to forward topology collection
requests.
System view
ntdp timer port-delay
Use the ntdp timer port-delay command to set the delay that a port waits to forward the topology
collection request packet after the last port forwards it.
System view
ntp-service access
Use the ntp-service access command to set the authority to access the local equipment.
System view
ntp-service authentication enable
Use the ntp-service authentication enable command to enable the NTP-service authentication
function, if no IP address is specified, the switch automatically selects 224.0.1.1 as the multicast IP address.
System view
ntp-service authentication-keyid
Use the ntp-service authentication-keyid command to set NTP authentication key.
System view
ntp-service broadcast-client
Use the ntp-service broadcast-client command to configure NTP broadcast client mode.
VLAN Interface view
ntp-service broadcast-server
Use the ntp-service broadcast-server command to configure NTP broadcast server mode.
VLAN Interface view
ntp-service in-interface disable
Use the ntp-service in-interface disable command to disable an interface to receive NTP message.
VLAN Interface view
ntp-service max-dynamic sessions
Use the ntp-service max-dynamic-sessions command to set how many sessions can be created locally.
System view
ntp-service multicast-client
Use the ntp-service multicast-client command to configure the NTP multicast client mode.
VLAN Interface view
ntp-service multicast-server
Use the ntp-service multicast-server command to configure NTP multicast server mode.
VLAN Interface view
ntp-service reliable authentication-keyid
Use the ntp-service reliable authentication-keyid command to configure the key as reliable.
System view
ntp-service source-interface
Use the ntp-service source-interface command to designate an interface to transmit NTP message.
System view
ntp-service unicast-peer
Use the ntp-service unicast-peer command to configure NTP peer mode.
System view
ntp-service unicast-server
Use the ntp-service unicast-server command to configure NTP server mode.
System view
option
Use the option command to specify the way to generate detecting results.
Detecting Group view
originating-rp
Use the originating-rp command to allow MSDP peer to use the specified interface IP address as the RP
address in the SA message when the MSDP peer creates SA messages.
MSDP view
ospf
Using the ospf command, you can enable the OSPF protocol.
System view