Need help?Do you have a question about the 3Com Baseline Switch 2952-SFP Plus and is the answer not in the manual?
General| Model | 3Com Baseline Switch 2952-SFP Plus |
|---|---|
| Switching Capacity | 176 Gbps |
| Layer | Layer 2 |
| Jumbo Frame Support | Yes |
| Manageable | Yes |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Ports | 48 x 10/100/1000 + 4 x SFP+ |
| Power Supply | AC 100-240V, 50/60 Hz |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating Humidity | 10% to 90% (non-condensing) |
| Storage Humidity | 5% to 95% (non-condensing) |
| MAC Address Table Size | 16K entries |
Describes the console, 10/100/1000Base-T Ethernet, and 1000Base-X SFP interfaces.
Explains the status and meaning of various LEDs on the switch for operational monitoring.
Essential safety rules to prevent injury and device damage during installation.
Specifies requirements for the physical location, including clearance and grounding.
Step-by-step guide for mounting the switch into a 19-inch rack using brackets.
Procedure for securely installing the switch into a standard equipment rack.
Detailed instructions for connecting the PGND cable for grounding and safety.
Steps to connect the AC power cord to the switch for operation.
Instructions for connecting an RPS DC power cord for redundant power input.
Configure terminal emulation software settings for switch communication.
Troubleshooting steps for common issues encountered during file loading.
Procedures for recovering lost user or Boot ROM passwords.
To Next Page