32 CHAPTER 4: RUNNING THE SETUP WIZARD
Routing Mode over ATM (RFC 1483 Routed Mode)
To set up the Router for use with an RFC1483 routed connection:
Figure 21 Routing Mode Screen
1 Enter your Internet IP address in the WAN IP text box.
2 Enter the subnet mask in the Subnet Mask text box.
3 Enter the default router in the Default Gateway text box.
4 Enter the DNS address in the DNS text box.
5 Enter your VPI and VCI information in the VPI/VCI text boxes.
6 Select the encapsulation type (LLC or VC MUX) in the Encapsulation
drop-down list. This information will have been provided to you by your
ISP.
7 Check all of your settings, and then click Next.The Wireless Settings
screen is displayed.
Figure 22 Wireless Settings Screen
To Next Page
Loading...
