3Com SUPERSTACK 3 3226 Release Notes

2 SUPERSTACK
®
3 SWITCH 3226 AND SWITCH 3250 SOFTWARE VERSION 1.02 RELEASE NOTES
The software is available in two versions:
■ s3201_02.bin — Provides normal levels of
encryption with keys of up to 56 bits in length.
■ s3201_02s.bin — Provides higher levels of
encryption including 168-bit 3DES and
256-bit AES.
The Switch ships with software providing normal
levels of encryption.
Errors and Omissions
The system console speed command is
available on the unit but has been omitted from the
“SuperStack 3 Switch 3226 and Switch 3250
Management Quick Reference Guide” and the
“SuperStack 3 Switch 3226 and Switch 3250
Management Interface Reference Guide”.
To change the speed of the console port:
1 Enter system console speed from the top-level
menu of the Command Line Interface.
2 Enter the speed at which you want to set the console
port or ? to see a list of available speeds.
SuperStack 3 Switch 3226 and Switch 3250 Getting
Started Guide
Pages 15 and 16 contain the following statement:
“The console port uses a standard null modem
cable and is set to auto-baud, 8 data bits, no parity
and 1 stop bit.”
This is incorrect. It should read:
“The console port uses a standard null modem
cable and is set to 19200 baud, 8 data bits, no
parity and 1 stop bit.”
If you change the speed, make a note of the new
setting. If you cannot connect using the console port
and do not know the speed at which it is set, connect
using a network port and enter the
system console speed command to check the
speed of the console port.
Enhancements and Fixes for Known Faults
The following features and enhancements are
supported in version 1.02.
Web Interface
The unit only allows printable ASCII characters, with
character codes between 32 and 127, to be used for
strings such as the unit location or VLAN name.
Characters such as those used for accented letters in
non-English languages are rejected. In previous
firmware these characters where rejected with a

3Com SUPERSTACK 3 3226 Specifications