314 CHAPTER 12: FILE SYSTEM MANAGEMENT
CAUTION: If the flash memory of the Switch is not enough, you need to first
delete the existing programs in the flash memory and then upload the new ones.
3 Type in the correct command in User View to establish FTP connection, then enter
the correct username and password to log into the FTP server.
<SW5500> ftp 2.2.2.2
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):switch
331 Give me your password, please
Password:*****
230 Logged in successfully
[ftp]
4 Enter the authorized directory of the FTP server.
[ftp]cd switch
5 Use the get command to download the switch.app from the FTP server to the
flash directory on the FTP server.
[ftp]get switch.app
[ftp]get boot.app
6 Use the quit command to release the FTP connection and return to User View.
[ftp]quit
<SW5500>
7 Upgrade BootROM.
<SW5500> boot bootrom boot.btm
This will update BootRom file on unit 1. Continue? [Y/N]y
Upgrading BOOTROM, please wait...
Upgrade BOOTROM succeeded!
8 Use the boot boot-loader command to specify the downloaded program as the
application at the next login and reboot the Switch.
<SW5500> boot boot-loader switch.app
<SW5500>display boot-loader
The app to boot at the next time is: flash:/Switch.app
The app to boot of board 0 at this time is: flash:/PLAT.APP
<SW5500> reboot
System Maintenance
and Debugging
Basic System
Configuration
Setting the System Name for the Switch
Perform the operation of sysname command in the System View.
Table 361 Set the Name for the Switch
Operation Command
Set the Switch system name sysname
sysname
Restore Switch system name to default value undo sysname
To Next Page