Displaying the State and Information of the System 315
Setting the System Clock
Perform the operation of clock datetime command in the User View.
Tab le 362 Set the System Clock
Setting the Time Zone
You can configure the name of the local time zone and the time difference
between the local time and the standard Universal Time Coordinated (UTC).
Perform the following operations in the User View.
Tab le 363 Setting the Time Zone
By default, the UTC time zone is adopted.
Setting the Summer Time
You can set the name, start and end time of the summer time.
Perform the following operations in the User View.
Tab le 364 Setting the Summer Time
By default, the summer time is not set.
Displaying the State
and Information of
the System
The display commands can be classified as follows according to their functions.
■ Commands for displaying the system configuration information
■ Commands for displaying the system running state
■ Commands for displaying the system statistics information
For the display commands related to each protocol and different ports, refer to
the relevant chapters. The following
display commands are used for displaying
the system state and the statistics information.
Operation Command
Set the system clock clock datetime
time date
Operation Command
Set the local time clock timezone
zone_name
{ add | minus
}
HH:MM:SS
Restore to the default UTC time zone undo clock timezone
Operation Command
Set the name and range of the summer
time which is effective for one year
clock summer-time
zone_name
one-off
start-time start-date end-time
end-date offset-time
Set the name and range of the summer
time whic is effective for every year
clock summer-time zone name repeating
{ start-time start-date end-time
end-date | start-time start-year
start-month start-week start-day
end-time end-year end-month end-week
end-day } offset-time
Remove the setting of the summer time undo clock summer-time
To Next Page