3M 3100 - Page 7

78-8127-6830-3-C 7
5.4 Start 2" (50 mm) from Scotch
®
Linerless Rubber Splicing Tape 130C and apply
one half-lapped layer of Scotch
®
Heavy Duty Mining Tape 31 with mastic side
toward the cable continuing 2" (50 mm) past the end of the 130C tape. Always
wrap the 31 tape toward the machine end of the cable.
2" (50 mm)
past end of
previous layer
2" (50 mm)
past end of
previous layer
Scotch
®
Heavy Duty Mining Tape 31
(Mastic side toward cable)
Machine End
Start taping here
Figure 14
5.5 Starting 1" (25 mm) past the 31 tape, apply 3 half-lapped layers of
3M
™
Temflex
™
Vinyl Electrical Tape 1700P to each end to temporarily secure
the ends of the 31 tape until the tape reaches full bond.
1"
(25 mm)
1"
(25 mm)
3M
™
Temflex
™
Vinyl Electrical Tape 1700P
Figure 15